User's Manual
Table Of Contents
- 1 Introduction
- 2 Antenna and Repeater Installation Requirements
- 3 Dual-Band Repeater Installation
- 4 Two Dual Units (Quad-band) Installation
- 4.1 Overview
- 4.2 View of the Quad Band Installation
- 4.3 Required Tools and Materials
- 4.4 DIGImini Tri/Quad-band Kit
- 4.5 Upgrading to a Quad-Band System
- 5 Setup and Configuration
- 6 DMCU Installation and Management
- 1
- 6.5.2.1 Band Tabs
- 6.5.2.2 CMU Tabs
- 6.5.2.3 Operation Buttons
- 6.6 Basic Configuration Procedures
- 6.7 Communication and System Parameters
- 6.8 DMCU Administration
- 6.9 CMU Monitoring and Troubleshooting Options
- Appendix A: Specifications (@+25 C)
AXELL DIGIMINI- AMERICAS REPEATER
PRODUCT DESCRIPTION AND USER’S MANUAL
46 DIGImini Americas User Manual Rev 3.5 © Axell Wireless Ltd
6 DMCU Installation and Management
NOTE: In case of two cascaded DIGImini repeaters, a single DMCU serves both repeaters.
The DMCU is a separately ordered unit that provides various controls and monitoring functionality,
including: Ethernet access, modem functionality (i.e GSM/GPRS, CDMA) and dry-contact alarms. A
single unit can serve either a single Repeater or a Quad-band assembly comprising of two units.
The DMCU modem antenna is internal, where communication is established with the Repeater via
the external Modem connector at the side of the Repeater.
The DMCU is mounted externally, adjacent to the Repeater, and connected to the Repeater (or to one
of the Repeaters in case of a quad-band repeater assembly) via two cables: RS485 and SMA. The unit
is powered by the Repeater – no power-supply is required.
This section describes the DMCU interfaces, installation procedure and management capabilities
provided by the unit.
Figure 6-1: DMCU