User's Manual
Table Of Contents
- 1 Introduction
- 2 Antenna and Repeater Installation Requirements
- 3 Dual-Band Repeater Installation
- 4 Two Dual Units (Quad-band) Installation
- 4.1 Overview
- 4.2 View of the Quad Band Installation
- 4.3 Required Tools and Materials
- 4.4 DIGImini Tri/Quad-band Kit
- 4.5 Upgrading to a Quad-Band System
- 5 Setup and Configuration
- 6 DMCU Installation and Management
- 1
- 6.5.2.1 Band Tabs
- 6.5.2.2 CMU Tabs
- 6.5.2.3 Operation Buttons
- 6.6 Basic Configuration Procedures
- 6.7 Communication and System Parameters
- 6.8 DMCU Administration
- 6.9 CMU Monitoring and Troubleshooting Options
- Appendix A: Specifications (@+25 C)
AXELL DIGIMINI- AMERICAS REPEATER
PRODUCT DESCRIPTION AND USER’S MANUAL
40 DIGImini Americas User Manual Rev 3.5 © Axell Wireless Ltd
To access the Band Information window
1. From the Tree Pane, select the band (e.g. 850-1900).
2. Select the Band Info tab. The relevant parameters are displayed.
5.2.6 Adjusting the Signal Levels and Configuring Channels
The Control and Params (parameters) window is used to configure the sub-bands and Max UL/DL
Power for the selected band. A dedicated filter configuration dialog is provided for each of the
supported bands (i.e. 700/1700/850/1900) in the Control and Params tab. The dialogs and
configuration procedures are identical for each band, except for the parameter values.
Up to six sub-bands referred to as filters can be defined per two bands, where each sub-band is
individually defined by setting the following:
• Bandwidth - start and stop frequency
• Maximum power
• Maximum gain
• Gain delta
The defined sub-bands are displayed in the lower part of the screen for reference.