User's Manual
Table Of Contents
- 1 Introduction
- 2 Antenna and Repeater Installation Requirements
- 3 Dual-Band Repeater Installation
- 4 Two Dual Units (Quad-band) Installation
- 4.1 Overview
- 4.2 View of the Quad Band Installation
- 4.3 Required Tools and Materials
- 4.4 DIGImini Tri/Quad-band Kit
- 4.5 Upgrading to a Quad-Band System
- 5 Setup and Configuration
- 6 DMCU Installation and Management
- 1
- 6.5.2.1 Band Tabs
- 6.5.2.2 CMU Tabs
- 6.5.2.3 Operation Buttons
- 6.6 Basic Configuration Procedures
- 6.7 Communication and System Parameters
- 6.8 DMCU Administration
- 6.9 CMU Monitoring and Troubleshooting Options
- Appendix A: Specifications (@+25 C)
AXELL DIGIMINI- AMERICAS REPEATER
PRODUCT DESCRIPTION AND USER’S MANUAL
© Axell Wireless Ltd DIGImini Americas User Manual Rev 3.5 37
5.2 Navigating the Web GUI Application
This section describes how to navigate the Web Management application. The Web Access interface
provides Repeater RF parameters control and monitoring options. The displayed bands depend on the
supported configuration: Single, Dual, Triple or Quad band configuration.
NOTE: The CMU (Control Monitoring Unit) item in the topology tree is only accessible for sessions
opened via the Digital Monitoring Control Unit (DMCU) - see section
6.5.2 for details. For sessions
opened by direct connection to a DIGImini front panel, the CMU item will appear but will not be
accessible.
Figure 5-3. Example of Web GUI Screen (shows dual-band)
Band Item
Pane related to
selected tree
item
Operation
Buttons
Tabs related to
Band item
User
Management