User's Manual
Table Of Contents
- 1 Introduction
- 2 Antenna and Repeater Installation Requirements
- 3 Dual-Band Repeater Installation
- 4 Two Dual Units (Quad-band) Installation
- 4.1 Overview
- 4.2 View of the Quad Band Installation
- 4.3 Required Tools and Materials
- 4.4 DIGImini Tri/Quad-band Kit
- 4.5 Upgrading to a Quad-Band System
- 5 Setup and Configuration
- 6 DMCU Installation and Management
- 1
- 6.5.2.1 Band Tabs
- 6.5.2.2 CMU Tabs
- 6.5.2.3 Operation Buttons
- 6.6 Basic Configuration Procedures
- 6.7 Communication and System Parameters
- 6.8 DMCU Administration
- 6.9 CMU Monitoring and Troubleshooting Options
- Appendix A: Specifications (@+25 C)
AXELL DIGIMINI- AMERICAS REPEATER
PRODUCT DESCRIPTION AND USER’S MANUAL
36 DIGImini Americas User Manual Rev 3.5 © Axell Wireless Ltd
2. If connecting to the Tri/Quad-band assembly, connect the cable to any of the two repeaters. The
Web GUI will allow for configuration of both repeaters.
Figure
5-2: Cascaded DIGImini Tri-band and Quad-band
3. In the address line, type digimini or enter the default IP address of the Repeater.
http://192.168.1.253. A session will be established with the Repeater and the login dialog
appears.
4. Type the default User Name admin and the default Password admin.
NOTE: Bothe entries are case sensitive and must be entered with lower case letters.
5. Click Login. The application main window appears.
6. Quickly review the following section describing the application window and then proceed to
configure the signal levels according to section
5.2.3.
Ethernet cross-
cable
Connect to either unit