User's Manual
Table Of Contents
- 1 Introduction
- 2 Antenna and Repeater Installation Requirements
- 3 Dual-Band Repeater Installation
- 4 Two Dual Units (Quad-band) Installation
- 4.1 Overview
- 4.2 View of the Quad Band Installation
- 4.3 Required Tools and Materials
- 4.4 DIGImini Tri/Quad-band Kit
- 4.5 Upgrading to a Quad-Band System
- 5 Setup and Configuration
- 6 DMCU Installation and Management
- 1
- 6.5.2.1 Band Tabs
- 6.5.2.2 CMU Tabs
- 6.5.2.3 Operation Buttons
- 6.6 Basic Configuration Procedures
- 6.7 Communication and System Parameters
- 6.8 DMCU Administration
- 6.9 CMU Monitoring and Troubleshooting Options
- Appendix A: Specifications (@+25 C)
AXELL DIGIMINI- AMERICAS REPEATER
PRODUCT DESCRIPTION AND USER’S MANUAL
34 DIGImini Americas User Manual Rev 3.5 © Axell Wireless Ltd
4.5.6 Power Up
To power up
1. Connect each Power Supply (AC/DC Converter) output to a Repeater front panel DC power
connector.
2. Connect each of the Repeater P.S. units’ to the AC power outlet.
Figure
4-17. Powering Up (shown with illustration of Combiner)
4.5.7 What Next?
• Installations without DIGImini Control Unit (DMCU) – continue to 5 - Setup and Configuration.
• Installations with DMCU – refer to Chapter 6 - DMCU Installation and Management.
Connect this side
to 110/240 VAC
Donor Antenna
Connect this side to
Repeater
front panel
DC connector