User's Manual
Table Of Contents
- 1 Introduction
- 2 Antenna and Repeater Installation Requirements
- 3 Dual-Band Repeater Installation
- 4 Two Dual Units (Quad-band) Installation
- 4.1 Overview
- 4.2 View of the Quad Band Installation
- 4.3 Required Tools and Materials
- 4.4 DIGImini Tri/Quad-band Kit
- 4.5 Upgrading to a Quad-Band System
- 5 Setup and Configuration
- 6 DMCU Installation and Management
- 1
- 6.5.2.1 Band Tabs
- 6.5.2.2 CMU Tabs
- 6.5.2.3 Operation Buttons
- 6.6 Basic Configuration Procedures
- 6.7 Communication and System Parameters
- 6.8 DMCU Administration
- 6.9 CMU Monitoring and Troubleshooting Options
- Appendix A: Specifications (@+25 C)
AXELL DIGIMINI- AMERICAS REPEATER
PRODUCT DESCRIPTION AND USER’S MANUAL
© Axell Wireless Ltd DIGImini Americas User Manual Rev 3.5 27
7. Carefully, connect the supplied flat cable between the two connectors as shown below. Verify
that the flat-cable is securely connected.
NOTE: Handle Flat Cable with care when connecting.
Figure
4-10. Interconnecting Flat cable
8. Cover the flat-cable with the provided Flat Cable Cover Plate and secure using the four screws.
Choose the appropriate cover plate (and also label for some plates) according to the criteria
described in following section.
Figure
4-11. Assembling Interconnecting Cover Plate
Plate covering
flat cable