User's Manual
Table Of Contents
- 1 Introduction
- 2 Antenna and Repeater Installation Requirements
- 3 Dual-Band Repeater Installation
- 4 Two Dual Units (Quad-band) Installation
- 4.1 Overview
- 4.2 View of the Quad Band Installation
- 4.3 Required Tools and Materials
- 4.4 DIGImini Tri/Quad-band Kit
- 4.5 Upgrading to a Quad-Band System
- 5 Setup and Configuration
- 6 DMCU Installation and Management
- 1
- 6.5.2.1 Band Tabs
- 6.5.2.2 CMU Tabs
- 6.5.2.3 Operation Buttons
- 6.6 Basic Configuration Procedures
- 6.7 Communication and System Parameters
- 6.8 DMCU Administration
- 6.9 CMU Monitoring and Troubleshooting Options
- Appendix A: Specifications (@+25 C)
AXELL DIGIMINI- AMERICAS REPEATER
PRODUCT DESCRIPTION AND USER’S MANUAL
22 DIGImini Americas User Manual Rev 3.5 © Axell Wireless Ltd
4.4.2 Middle layer Items
NOTE: References to Type I and Type II DIGImini models are explained in the following sections
when the relevant instructions are given.
Figure 4-4. Quad-Band Upgrade Accessory Kit -Middle Layer items
4.4.3 Bottom Layer Items
Figure 4-5. Quad-Band Upgrade Accessory Kit-Bottom Layer Items
Flat Cable +
Combiner
Spacers
X1 Quad-band
plate for Type I
+ Type II units
configuration
Frequency
Labels for
Type-
2
combinations
x3 Quad-band
plate for two
Type I units
RF Combiner
RF Combiner
x1 Quad-band
plate for two
Type II
configurations
2 x Expansion, Side
Brackets