User's Manual
Table Of Contents
- 1 Introduction
- 2 Antenna and Repeater Installation Requirements
- 3 Dual-Band Repeater Installation
- 4 Two Dual Units (Quad-band) Installation
- 4.1 Overview
- 4.2 View of the Quad Band Installation
- 4.3 Required Tools and Materials
- 4.4 DIGImini Tri/Quad-band Kit
- 4.5 Upgrading to a Quad-Band System
- 5 Setup and Configuration
- 6 DMCU Installation and Management
- 1
- 6.5.2.1 Band Tabs
- 6.5.2.2 CMU Tabs
- 6.5.2.3 Operation Buttons
- 6.6 Basic Configuration Procedures
- 6.7 Communication and System Parameters
- 6.8 DMCU Administration
- 6.9 CMU Monitoring and Troubleshooting Options
- Appendix A: Specifications (@+25 C)
AXELL DIGIMINI- AMERICAS REPEATER
PRODUCT DESCRIPTION AND USER’S MANUAL
18 DIGImini Americas User Manual Rev 3.5 © Axell Wireless Ltd
3.1.7 Power Up
To power up
Connect the Repeater P.S. to the AC power outlet and to the Repeater DC connector.
Figure 3-7. Powering Up
3.1.8 What Next?
• Installations without DIGImini Control Unit (DMCU) – continue to Chapter 5 - Setup and
Configuration
• Installations with DMCU – refer to Chapter 6 - DMCU Installation and Management.
Connect to
Repeater Power
Connect to
110/240 VAC