User's Manual
Table Of Contents
- 1 Introduction
- 2 Antenna and Repeater Installation Requirements
- 3 Dual-Band Repeater Installation
- 4 Two Dual Units (Quad-band) Installation
- 4.1 Overview
- 4.2 View of the Quad Band Installation
- 4.3 Required Tools and Materials
- 4.4 DIGImini Tri/Quad-band Kit
- 4.5 Upgrading to a Quad-Band System
- 5 Setup and Configuration
- 6 DMCU Installation and Management
- 1
- 6.5.2.1 Band Tabs
- 6.5.2.2 CMU Tabs
- 6.5.2.3 Operation Buttons
- 6.6 Basic Configuration Procedures
- 6.7 Communication and System Parameters
- 6.8 DMCU Administration
- 6.9 CMU Monitoring and Troubleshooting Options
- Appendix A: Specifications (@+25 C)
AXELL DIGIMINI- AMERICAS REPEATER
PRODUCT DESCRIPTION AND USER’S MANUAL
6 DIGImini Americas User Manual Rev 3.5 © Axell Wireless Ltd
1.6.2 Side Panel Interfaces
The DIGImini side panel supports the DMCU interfaces and the side bolts used for hanging the unit
on the wall bracket.
Figure 1-3. DIGImini Side Panel
Side Connector Description
Modem Modem Antenna connection - relevant if a DMCU is available.
RS485 RS485 connection to DMCU option.
1.7 DIGImini Power Supply
The power supply requires assembly only during an upgrade procedure from a single-band or dual-
band to a triple-band or quad-band solutions in which two DIGImini units are cascaded. Otherwise, it
is preassembled.
Figure 1-4: Repeater Power Supply
Connect to
110/240 VAC
power source
Connect to Front
panel DC power
(12V) connector
Side bolts for hanging
the Repeater on the wall
bracket (x2 on each side)
DMCU Antenna
connection
DMCU RS485
connection