User's Manual
Table Of Contents
- 1 Introduction
- 2 Antenna and Repeater Installation Requirements
- 3 Dual-Band Repeater Installation
- 4 Two Dual Units (Quad-band) Installation
- 4.1 Overview
- 4.2 View of the Quad Band Installation
- 4.3 Required Tools and Materials
- 4.4 DIGImini Tri/Quad-band Kit
- 4.5 Upgrading to a Quad-Band System
- 5 Setup and Configuration
- 6 DMCU Installation and Management
- 1
- 6.5.2.1 Band Tabs
- 6.5.2.2 CMU Tabs
- 6.5.2.3 Operation Buttons
- 6.6 Basic Configuration Procedures
- 6.7 Communication and System Parameters
- 6.8 DMCU Administration
- 6.9 CMU Monitoring and Troubleshooting Options
- Appendix A: Specifications (@+25 C)
AXELL DIGIMINI- AMERICAS REPEATER
PRODUCT DESCRIPTION AND USER’S MANUAL
© Axell Wireless Ltd DIGImini Americas User Manual Rev 3.5 5
1.6.1 Front Panel Interfaces
The image below shows the unit (the wallmount bracket is not shown).
Figure
1-2: DIGImini Single/Dual-Band Front Panel
The following table provides a description of the front panel connectors.
Port Description
MOBILE Service antenna connections.
BASE Donor antenna connections.
DC Power (12V) Circular, 4-PIN.
RJ 45 Local management and setup port – to be used only if DMCU is not
installed.
ATTENTION! This port is only for local access. Do not connect this
port to your network. It may affect your network!
*Connectors not in use and no termination is required.
The following table provides a description of the front panel LED indicators (See 5.3.2 for more
info.).
LED Description
Band specific LED
(e.g. 850, 1900, etc)
Downlink path status and RSSI indication:
• Steady Green – Normal operation
• Orange – Major malfunction
• Red – Blinking panel mask
Status LEDs
N/A*
Power
Mobile
N/A*
Base
ETH
RJ45