User's Manual
Table Of Contents
- 1 Introduction
- 2 Antenna and Repeater Installation Requirements
- 3 Dual-Band Repeater Installation
- 4 Two Dual Units (Quad-band) Installation
- 4.1 Overview
- 4.2 View of the Quad Band Installation
- 4.3 Required Tools and Materials
- 4.4 DIGImini Tri/Quad-band Kit
- 4.5 Upgrading to a Quad-Band System
- 5 Setup and Configuration
- 6 DMCU Installation and Management
- 1
- 6.5.2.1 Band Tabs
- 6.5.2.2 CMU Tabs
- 6.5.2.3 Operation Buttons
- 6.6 Basic Configuration Procedures
- 6.7 Communication and System Parameters
- 6.8 DMCU Administration
- 6.9 CMU Monitoring and Troubleshooting Options
- Appendix A: Specifications (@+25 C)
AXELL DIGIMINI- AMERICAS REPEATER
PRODUCT DESCRIPTION AND USER’S MANUAL
4 DIGImini Americas User Manual Rev 3.5 © Axell Wireless Ltd
1.5 DMCU - Optional
The DIGImini Control Unit (DMCU) is an optional control unit that is ordered separately. The
DMCU is installed externally, where one unit can support a single DIGImini unit as well as an
upgrade to a DIGImini Quad-band assembly. The DMCU provides complete remote control and
monitoring capabilities over GPRS or CDMA (model dependent), including:
• Remote control via SMS
• Remote alarming through SNMP alarm traps
Refer to Chapter
6 - DMCU Installation and Management for the complete description of the DMCU
and the configuration and management capabilities provided by the unit.
1.6 DIGImini Interfaces
The DIGImini is supplied in two physical configurations: Single unit supporting either one or two
bands; two cascaded units supporting up to four bands. Power supplies dedicated to each unit are
connected externally.
An optional DMCU supporting an external modem is also connected externally, where a single
DMCU can serve two cascaded units.
The interfaces are located on the front and on the side panels.