User's Manual

AXELL DIGIMINI- AMERICAS REPEATER
PRODUCT DESCRIPTION AND USER’S MANUAL
66 Doc PN 4000003431 Rev. 3.8 © Axell Wireless Ltd
6.6 Basic Configuration Procedures
Begin by performing the following procedures:
• Configure Signal levels and Channels
• Set the Date and Time
• If external alarms have been connected – enable the external alarms
6.6.1 Configuring Signal Levels and Channels
For signal level and channel configuration refer to Chapter 5.2.3 - Signal Levels and Channel
Configuration.
6.6.2 Setting Date and Time
It is important to set the correct date and time on the unit since this provides the timestamp for each
logged event and alarm.
To set the Repeaters date and time
1. Click on CMU in the tree pane.
2. Click on Date & Time in the menu bar. The following dialog appears.
3. Set the date and time parameters and click on Set.
4. Reset the CMU (as described in the following section).