User's Manual

AXELL DIGIMINI- AMERICAS REPEATER

PRODUCT DESCRIPTION AND USER’S MANUAL

3 Dual-Band Repeater Installation

This section describes two types of installation procedures:

• Single DIGImini unit – section 3.1

• Quad-band assembly consisting of two DIGImini units – section 1 4.

3.1 Single Unit Installation

3.1.1 Overview

NOTE: The Donor and Mobile antennas can be positioned and installed (without being connected

to the Repeater) at any time either before or after mounting and grounding the Repeater.

1. Unpack the Repeater kit.

2. Mount the Bracket on the wall, hang the Repeater and Power Supply on the bracket (do not

connect power).

3. Perform the required isolation and link tests.

4. Connect the antennas.

5. Power-on the Repeater.

6. If a DMCU is available, mount the unit (adjacent to the Repeater, on the wall, and connect to the

Repeater according to the instructions in Chapter

6 - DMCU Installation and Management.

3.1.2 Required Tools and Materials

The following is required in order to install the Repeater:

• Standard professional tool box

• A computer (i.e. laptop for running the setup)