User's Manual

AXELL DIGIMINI- AMERICAS REPEATER
PRODUCT DESCRIPTION AND USER’S MANUAL
60 Doc PN 4000003431 Rev. 3.8 © Axell Wireless Ltd
6.5 Opening a Web Session via the DMCU
Connect the computer and the Control Unit front panel Ethernet port with the supplied cable as
shown below.
NOTE: If connecting the DMCU to a Tri/Quad-band assembly, it may be connected to either of the
two DIGImini units. Local setup will then only be done via the DMCU's ETH port.
Figure
6-6. DMCU Connections
Configure the computer network parameters to communicate with the DMCU.
NOTE: The procedure may vary slightly depending on the operating system installed on your
computer. The following procedure is for Windows 7.
To Configure the Computer’s IP Parameters:
1. Click the Start menu and choose Control Panel.
2. In the Control Panel, click Network and Internet.
3. Click Network and Sharing Center and then click Local Area Connection.
ETH cross-cable