User's Manual

AXELL DIGIMINI- AMERICAS REPEATER

PRODUCT DESCRIPTION AND USER’S MANUAL

5 Setup and Configuration

NOTE: This section is relevant to installations that do not include DMCU. For installations with

DMCU unit, continue to Chapter

The Mini-Repeater is designed for simple plug-and-play operation, only requiring the setup of a

number of parameters (such as DL Output Power, bandwidth, and gain) through a local Web

connection and verifying that the system is operating properly.

The setup procedure consists of the following steps:

1. Open a local Web session to the Repeater.

If you are not familiar with the Axell Web Access application, it is recommended to quickly

review the Navigating the Web GUI Application section.

2. Adjust the signal levels and configuring the sub-bands and verify that no Alarms are generated.

5.1 Open a Direct Local WEB Session to the

Repeater

These instructions are valid only for installations without a DMCU.

To connect directly to the Repeater

1. Connect the supplied Ethernet cross-cable from the computer to the Repeaters’ front panel.

ATTENTION! Do not connect the Repeater ETH port to the network. It may affect your network!

Remote management is available only via a DMCU.

Figure 5-1. Ethernet Connection to a Single DIGImini Repeater