User's Manual
Table Of Contents
- 1 INTRODUCTION
- 2 Antenna Requirements
- 3 Installing the Signal Booster
- 4 Battery Charger Description and Installation
- 4.1 Charger Ordering Information
- 4.2 Charger Architecture
- 4.3 Charger Interfaces
- 4.4 Charger Installation Procedure
- 5 Setup and Commissioning
- 6 Administrative Operations
- 7 Monitoring and Troubleshooting
- Appendix A – Booster and Charger Specifications
D-MBR 3707-3708 PS NFPA CLASS B SIGNAL BOOSTER
PRODUCT DESCRIPTION AND USER’S MANUAL
Cobham Wireless – Coverage
Date: 6-Set-15
www.cobham.com/wireless
Doc. No. 00060CDUM Rev. 1.0 Page | 31
4.4.2 Charger Unpacking and Package Contents
Upon receiving the D-MBR-PS-NFPA Signal Booster, perform the following:
1. Examine the shipping container for damage before unpacking the unit.
2. Perform a visual inspection to reveal any physical damage to the equipment.
3. Verify that all of the items listed in the packing list are included. Otherwise contact your Cobham
Wireless service representative.
Battery Charger Package Contents
Battery Charger
CD containing User’s Manual
and USB driver
Mounting Brackets
1 x Alarms Connector
Circular 8 Pin (P/N 30WEC70500)
AC Cable
DC Connector and cable
Additional (supplied)
installation components:
Qty.
Description
4x M8x12 bolts for securing the Booster to the brackets
1x Insex tool for bolts
2 x keys
4.4.3 Charger Wallmount Procedure
The charger is mounted next to the Booster and the mounting instructions are identical to that of the
Booster.
Refer to section
3.4 for instructions.