User's Manual
Table Of Contents
- 1 INTRODUCTION
- 2 Antenna Requirements
- 3 Installing the Signal Booster
- 4 Battery Charger Description and Installation
- 4.1 Charger Ordering Information
- 4.2 Charger Architecture
- 4.3 Charger Interfaces
- 4.4 Charger Installation Procedure
- 5 Setup and Commissioning
- 6 Administrative Operations
- 7 Monitoring and Troubleshooting
- Appendix A – Booster and Charger Specifications
D-MBR 3707-3708 PS NFPA CLASS B SIGNAL BOOSTER
PRODUCT DESCRIPTION AND USER’S MANUAL
www.cobham.com/wireless Cobham Wireless – Coverage
Date: 6-Set-15
Page | 30 Doc. No. 00060CDUM Rev. 1.0
4.4 Charger Installation Procedure
The Charger installation procedure consist of the following steps.
Figure 4-4 Physical Installation Workflow
4.4.1 Charger Installation Location
The charger is installed
adjacent
to the Booster either on the wall or
vertically
in a rack.
Refer to section
3.2.2 for the relevant location criteria.
Step-1
• Installation Location
Step-2
• Unpacking
Step-3
• Mounting
Step-4
• Grounding
Step-5
• Power Connections
Step-6
• Connection to External Battery
Step-7
• Alarm connections