User's Manual
Table Of Contents
- 1 INTRODUCTION
- 2 Antenna Requirements
- 3 Installing the Signal Booster
- 4 Battery Charger Description and Installation
- 4.1 Charger Ordering Information
- 4.2 Charger Architecture
- 4.3 Charger Interfaces
- 4.4 Charger Installation Procedure
- 5 Setup and Commissioning
- 6 Administrative Operations
- 7 Monitoring and Troubleshooting
- Appendix A – Booster and Charger Specifications
D-MBR 3707-3708 PS NFPA CLASS B SIGNAL BOOSTER
PRODUCT DESCRIPTION AND USER’S MANUAL
www.cobham.com/wireless Cobham Wireless – Coverage
Date: 6-Set-15
Page | 20 Doc. No. 00060CDUM Rev. 1.0
Another example is of a unit installed on a stadium gantry. Again, the support can be in the form of a
cable harness loop, using the handle of the unit and part of the gantry structure.
ATTENTION!! Any other SECURE method can be used.
Figure 3-12: Example 2 of Additional Fixing to Gantry