User's Manual

© Axell Wireless Ltd
3.
Set the System Level parameters:
•
RF Transmission Enable
that it
is checked (RF transmission ON).
NOTE: RF transmission can be disabled by the system if the Shut Down mechanism is
enabled and the criteria activated the mechanism is fulfilled.
•
Shut Down Mechanism
transmission if an excessively high input power (from the BTS side) is detected.
The shut down criteria is valid only after a specific period of time that valid
input power level is exceeded.
o RF
Transmission Parameter
o System
Mute
NOTE: If the high input power issue is resolved, then it is necessary to enable RF
transmission by checkmarking the
the System Mute
alarm (click Ack).
•
Max Composite DL Output Power
and click Send
. The
the adjacent field.
Smart-
ALC feature begins working.
• Set the
Max Composite UL Output Power
requirements.
NOTE: The Temperature shows the Repeater’s ambient temperature. The
Delta (dB) shows the d
elta from DL Output Power, below which the alarm 'Donor power is too
low' is activated.
4. Checkmark ON
for each filter to be configured. The configuration parameters in that
row will be available.
Defined BW:
Narrow band (N)
or
Wideband (W)
Axell D-
MBR 3007
PRODUC
T DESCRIPTION AND USER’S MANUAL
UMCD00013 Rev 2.2
Set the System Level parameters:
RF Transmission Enable
–
disables and enables unit RF transmission. V
is checked (RF transmission ON).
NOTE: RF transmission can be disabled by the system if the Shut Down mechanism is
enabled and the criteria activated the mechanism is fulfilled.
Shut Down Mechanism
– when
enabled, the system automatically disables RF
transmission if an excessively high input power (from the BTS side) is detected.
The shut down criteria is valid only after a specific period of time that valid
input power level is exceeded.
In that case:
Transmission Parameter
is
unchecked (transmission is OFF)
Mute
alarm (Alarms tab) is generated (RED).
NOTE: If the high input power issue is resolved, then it is necessary to enable RF
transmission by checkmarking the
RF Transmission Enable
parameter. In addition, reset
alarm (click Ack).
Max Composite DL Output Power
– set
according to your site requirements
. The
Measured
Composite DL Output Power
the adjacent field.
If the composite output power excee
ds the defined value, the
ALC feature begins working.
Max Composite UL Output Power
according to your site
NOTE: The Temperature shows the Repeater’s ambient temperature. The
elta from DL Output Power, below which the alarm 'Donor power is too
for each filter to be configured. The configuration parameters in that
Downlink Channels
Uplink Channels
MBR 3007
-3008-PS-NFPA
T DESCRIPTION AND USER’S MANUAL
31
disables and enables unit RF transmission. V
erify
NOTE: RF transmission can be disabled by the system if the Shut Down mechanism is
enabled, the system automatically disables RF
transmission if an excessively high input power (from the BTS side) is detected.
The shut down criteria is valid only after a specific period of time that valid
unchecked (transmission is OFF)
NOTE: If the high input power issue is resolved, then it is necessary to enable RF
parameter. In addition, reset
according to your site requirements
Composite DL Output Power
is displayed in
ds the defined value, the
according to your site
NOTE: The Temperature shows the Repeater’s ambient temperature. The
DL Output Threshold
elta from DL Output Power, below which the alarm 'Donor power is too
for each filter to be configured. The configuration parameters in that
Uplink Channels