User's Manual
Table Of Contents
- 1 INTRODUCTION
- 2 Antenna Requirements
- 3 Installing the Signal Booster
- 4 Battery Charger Description and Installation
- 4.1 Charger Ordering Information
- 4.2 Charger Architecture
- 4.3 Charger Interfaces
- 4.4 Charger Installation Procedure
- 5 Setup and Commissioning
- 6 Administrative Operations
- 7 Monitoring and Troubleshooting
- Appendix A – Booster and Charger Specifications
D-MBR 3707-3708 PS NFPA CLASS B SIGNAL BOOSTER
PRODUCT DESCRIPTION AND USER’S MANUAL
Cobham Wireless – Coverage
Date: 6-Set-15
www.cobham.com/wireless
Doc. No. 00060CDUM Rev. 1.0 Page | 47
5.6 IP Address and SNMP Notifications
This section describes how to define the following parameters:
• Booster’s IP Address and SNMP notifications management
• AEM management support
• Auto-replace
All options are defined via the Communication Configuration Screen
To configure the IP Address and SNMP Notifications
1. Click on CMU in the left pane and select the Communication Configuration tab. The
following screen appears.
Figure 5-16. Communication Configuration Dialog
The following areas are relevant to this Booster installation.
Area Description
IP Configuration Used to define Static IP Address and DHCP Address.
AEM
Configuration
Used to define auto-replacement options for AEM management.
SNMP Trap
options
This includes enabling SNMP Trap options and defining the relevant
parameters.
AEM Used to configure the repeater for AEM support
SNMP notifications
Click CMU
Click
Communication
AEM Config
SNMP Trap
Config
IP Address
config