User's Manual
Table Of Contents
- 1 INTRODUCTION
- 2 Antenna Requirements
- 3 Installing the Signal Booster
- 4 Battery Charger Description and Installation
- 4.1 Charger Ordering Information
- 4.2 Charger Architecture
- 4.3 Charger Interfaces
- 4.4 Charger Installation Procedure
- 5 Setup and Commissioning
- 6 Administrative Operations
- 7 Monitoring and Troubleshooting
- Appendix A – Booster and Charger Specifications
D-MBR 3707-3708 PS NFPA CLASS B SIGNAL BOOSTER
PRODUCT DESCRIPTION AND USER’S MANUAL
www.cobham.com/wireless Cobham Wireless – Coverage
Date: 6-Set-15
Page | 40 Doc. No. 00060CDUM Rev. 1.0
5.2.2.4 CMU Pane and Tabs
This section describes the tabs available when the
CMU item
is selected in the left pane.
Item Description / Values
Axell-CMU Alarms Shows any external alarms that were generated.
CMU Info
Shows Booster level information such as SW and HW versions
and identification number. In addition, enables setting minimum
alarm levels (see
6.2.1).
Communication Configuration
Used to set IP Address and SNMP parameters (see
5.6)
Alarms Log
Booster level log of past and current alarms (see
7.2).
External Alarms
External alarm configuration options. (see
5.5)
Axell-CMU SW Upgrade
Options for Booster level software upgrade (see
6.4)
Modem Direct Access N/A