User's Manual
Table Of Contents
- 1 INTRODUCTION
- 2 Antenna Requirements
- 3 Installing the Signal Booster
- 4 Battery Charger Description and Installation
- 4.1 Charger Ordering Information
- 4.2 Charger Architecture
- 4.3 Charger Interfaces
- 4.4 Charger Installation Procedure
- 5 Setup and Commissioning
- 6 Administrative Operations
- 7 Monitoring and Troubleshooting
- Appendix A – Booster and Charger Specifications
D-MBR 3707-3708 PS NFPA CLASS B SIGNAL BOOSTER
PRODUCT DESCRIPTION AND USER’S MANUAL
Cobham Wireless – Coverage
Date: 6-Set-15
www.cobham.com/wireless
Doc. No. 00060CDUM Rev. 1.0 Page | 35
5 SETUP AND COMMISSIONING
This section describes the setup procedures for the D-MBR Booster.
5.1 Overview of the Commissioning Procedure
The Booster is designed for simple plug-and-play operation, only requiring the setup of a number of
parameters via a local Web connection and verifying that the system is operating properly.
Figure 5-1 Commissioning Overview
Step-1
• Open a local session
Step-2
• RF Parameters
Step-3
• Date and Time
Step-4
• External Alarms Config
Step-5
• IP Address
Step-6
• Password Change