User's Manual
Table Of Contents
- 1 INTRODUCTION
- 2 Antenna Requirements
- 3 Installing the Signal Booster
- 4 Battery Charger Description and Installation
- 4.1 Charger Ordering Information
- 4.2 Charger Architecture
- 4.3 Charger Interfaces
- 4.4 Charger Installation Procedure
- 5 Setup and Commissioning
- 6 Administrative Operations
- 7 Monitoring and Troubleshooting
- Appendix A – Booster and Charger Specifications
D-MBR 3707-3708 PS NFPA CLASS B SIGNAL BOOSTER
PRODUCT DESCRIPTION AND USER’S MANUAL
Cobham Wireless – Coverage
Date: 6-Set-15
www.cobham.com/wireless
Doc. No. 00060CDUM Rev. 1.0 Page | 19
3.4.4 Recommended Additional Fixing
SUGGESTED PRECAUTIONARY MEASURE!!
•
Brackets are provided to securely mount the Booster on the wall; however, as an
ADDITIONAL precautionary measure, it is recommended to further secure the Booster to the
wall (in addition to the bracket).
•
This can be done using any appropriate method.
•
It is the installer’s responsibility to ensure the Booster is installed in a secure manner.
The following figures provide EXAMPLES of additional fixings. In the examples, support is provided in
the form of a CABLE HARNESS LOOP that is looped around the Booster handle and secured to the
wall or part of the building support structure.
Figure 3-11: Example 1 of Additional Fixing to Wall