User's Manual
Table Of Contents
- 1 INTRODUCTION
- 2 Antenna Requirements
- 3 Installing the Signal Booster
- 4 Battery Charger Description and Installation
- 4.1 Charger Ordering Information
- 4.2 Charger Architecture
- 4.3 Charger Interfaces
- 4.4 Charger Installation Procedure
- 5 Setup and Commissioning
- 6 Administrative Operations
- 7 Monitoring and Troubleshooting
- Appendix A – Booster and Charger Specifications
D-MBR 3707-3708 PS NFPA CLASS B SIGNAL BOOSTER
PRODUCT DESCRIPTION AND USER’S MANUAL
Cobham Wireless – Coverage
Date: 6-Set-15
www.cobham.com/wireless
Doc. No. 00060CDUM Rev. 1.0 Page | 13
3.4 Mounting the System
Note the following:
• The mounting procedure is identical for both INDOOR and OUTDOOR installations.
• The mounting procedure is identical for both BOOSTER and BATTERY CHARGER (where relevant)
installations.
• The weight of the BOOSTER requires that TWO PEOPLE mount the unit on the wall.
• WASHERS are NOT SUPPLIED with the unit to be mounted.
• In addition to the bracket assembly, it is recommended to use additional fixings – an example is
given in section
3.4.4.
3.4.1 Bracket Assembly
NOTE: Assemble the brackets to the unit.
• Fix mounting brackets to the unit – use the supplied four M8 bolts and spring washers. Fix
mounting brackets to unit using M8 fixing bolts and supplied spring washers
Figure 3-2: Fix mounting brackets to Unit