User's Manual
Table Of Contents
- 1 INTRODUCTION
- 2 Antenna Requirements
- 3 Installing the Signal Booster
- 4 Battery Charger Description and Installation
- 4.1 Charger Ordering Information
- 4.2 Charger Architecture
- 4.3 Charger Interfaces
- 4.4 Charger Installation Procedure
- 5 Setup and Commissioning
- 6 Administrative Operations
- 7 Monitoring and Troubleshooting
- Appendix A – Booster and Charger Specifications
D-MBR 3707-3708 PS NFPA CLASS B SIGNAL BOOSTER
PRODUCT DESCRIPTION AND USER’S MANUAL
www.cobham.com/wireless Cobham Wireless – Coverage
Date: 6-Set-15
Page | 10 Doc. No. 00060CDUM Rev. 1.0
3 INSTALLING THE SIGNAL BOOSTER
This chapter describes the installation of the D-MBR 3707-3708 PS NFPA booster. For installations
that include the Feeder and Battery Charger, refer to Chapter-4 for the installations instructions.
WARNINGS!!!
• Follow all local safety regulations when installing the Signal Booster.
• Only qualified personnel are authorized to install and maintain the Signal Booster.
• Follow Electro-Static Discharge (ESD) precautions.
NOTE: If included in the installation), the Battery Charger is installed adjacent to the Booster. Refer
to chapter 4 for instructions on installing the Battery Charger.
3.1 Overview of the Physical Installation Procedure
WARNING!! Be sure to perform the power supply AFTER antennas are connected,
otherwise damage may be caused to the system.
Figure 3-1 Physical Installation Workflow
Step-1
• Installation Location
Step-2
• Unpacking
Step-3
• Mounting
Step-4
• Grounding
Step-5
• Antenna connections
Step-6
• Power connections
Step-7
• Alarm connections