User Manual

XELL

D-MBR-USA

EPEATER

PRODUCT DESCRIPTION AND USER’S MANUAL

IMPORTANT* After programming, remove the RS-232 cable for proper modem function on

the Verizon network.

6. After a few minutes, a Modem IP Address should appear on the CMU GUI screen. This indicates

the modem is functioning on the Verizon Network. The module is then set up for both voice and

data.

4.7.3 Direct Circuit Switch Connection

A. On the Repeater, set the Repeater Modem parameters (above) as follows:

• Communication - Direct CS

• To provide security, set the User Name and Password for the repeater (the same User

Name and Password will be defined on the dial-up connection).

• You may modify (optional) the Direct CS Modem IP – this is the Web address used

to open a Repeater session. Otherwise, the default displayed value can be used.

B. On your computer, set up a dial-up connection as follows:

1. Via Network Connections, create a Dial-up connection on your computer (Connect using a dial-

up modem). The procedure may vary slightly depending on your Operating System.

2. Define the parameters as follows:

• ISP connection name – user defined, recognizable name for this connection for future

reference.

• Phone Number – the number corresponding to the SIM card installed on the Repeater.

• User Name and Password – the User Name and Password (if assigned) that you

allocated in the Modem parameters in the Communication dialog (see previous

section).

C. Open a session to the Repeater:

1. On your computer, click the relevant dial-up connection item or the icon, to open a dial-up route

to the Repeater.

2. Open a Web Browser and enter the Direct CS Modem IP that is defined in the Modem

parameters on your Repeater. A session will be opened to the Repeater.