User Manual

A XELL D-MBR-USA R EPEATER
PRODUCT DESCRIPTION AND USER’S MANUAL
© Axell Wireless Ltd 19
4 Initial Setup and Commissioning
This section provides the setup procedures for the D-MBR-USA Repeater. The Repeater is designed
for simple plug-and-play operation, only requiring the setup of a number of parameters (such as DL
Output Power, bandwidth, and gain) through a local Web connection and verifying that the system is
operating properly.
The setup procedure consists of the following steps:
1. Open a local Web session to the Repeater (this requires configuring the communication
parameters of the computer used).
2. If you are not familiar with the Axell Web Access application, we suggest you quickly review the
section on Navigating the Web GUI Application. It is only a couple of pages and you will find it
useful.
3. For each service, adjust the signal levels and configuring the sub-bands.
4. After the required coverage is attained for the location, verify that no Alarms are generated
before connecting to the main control center.
5. Set the Repeater time and date.
6. Configure the external alarms.
7. Configure the communication and system parameters.
4.1 Open a Local WEB Session to the Repeater
4.1.1 Connect the Repeater to the Computer
Interconnect the Repeater Ethernet port and the computer Ethernet port using the supplied Ethernet
cross-cable.
Figure 5.D-MBR-USA and Computer Ethernet Connection
4.1.2 Configure the Computer Network Parameters
Configure the computer network parameters to communicate with the Repeater. Note that the
procedure may vary slightly depending on the operating system installed on your computer. The
following procedure is for Windows 7.
To configure the computer’s network parameters:
1. Click the Start menu and choose Control Panel.
2. In the Control Panel, click Network and Internet.
Ethernet cross-cable