User Manual

A XELL D-MBR-USA R EPEATER
PRODUCT DESCRIPTION AND USER’S MANUAL
© Axell Wireless Ltd 15
3.8 Antenna Connections
CAUTION! Do not connect the antenna cables to the Repeater before verifying the
installation parameters.
DO NOT POWER-UP the Repeater without either the antennas being connected or
the antenna connections terminated with dummy loads.
To connect the antennas to the Repeater
NOTE: If the coaxial cables are NOT weather-resistant type, wrap the exterior coaxial cables with
insulation and holding tape (Type 3M Rubber splicing tape) for environmental protection and to
ensure longer lifetime.
1. Install the antenna cables along their path to the Repeater, and connect them to the Antennas.
Note: Be sure to use low loss cables.
2. Connect the Donor antenna to the Repeater BASE port. (Donor antenna specifications and
installation criteria are described in section 2.1).
3. Verify all RF connectors are tightened and the cables and antennas are secured.
4. Connect the Service antenna to the Repeater MOBILE port. (Mobile antenna specifications and
installation criteria are described in section 2.2).
5. Verify all RF connectors are tightened and the cables and antennas are secured.