User's Manual
Table Of Contents
- High Selectivity Digital 700MHz Repeater
- Copyright © 2011 Axell Wireless Ltd
- Contact Information
- About This Manual
- For whom it is Intended
- Notice
- Confidential - Authorized Customer Use
- Disclaimer of Liability
- Safety Instructions and Warnings
- General Safety Warnings Concerning Use of This System
- Exclusive Remedies
- Table of Contents
- Introduction
- Antenna Requirements
- Installation requirements:
- Installing the Repeater
- Initial Setup and Commissioning
- Administrative Operations
- Monitoring and Troubleshooting
- Appendix: 3307D Specifications
AXELL 3307D REPEATER
PRODUCT DESCRIPTION AND USER’S MANUAL
2 © Axell Wireless Ltd
1
1
.
.
1
1
F
F
e
e
a
a
t
t
u
u
r
r
e
e
s
s
• Indoor Repeater supporting simultaneously the LTE band: Lower A,B,C and Upper C 700MHz
• Up to 8 or 12 (model dependent) software selectable non-contiguous sub-bands in any
combination
• Each sub-band can be set over the full LTE band for the following bandwidths: 1.4MHz, 3MHz,
5MHz, 10MHz or 15MHz or 20MHz to meet the LTE 36.106 standard
• Individual gain and power settings for each sub-band
• Composite downlink Output Power: + 33 dBm;
• Composite uplink Output Power: + 27 dBm
• RF Gain: 82 dB
• High linear amplification, high spectral purity and excellent out-of-band interference prevention
• SmartALC™ technology:
• Automatically sets optimum gain
• Prevents oscillations and balances coverage
• Ensures transparent network operation
• Highly accurate frequency selection
• Configuration backup and restore via simple, intuitive GUI options
• Wallmount
• Simple setup via an intuitive GUI application
• Supports SMS and SNMP fault notification
• Remote Web access monitoring and control via either an integrated Wireless CDMA or
GSM/GPRS modem (supporting Packet Switch)
• Simultaneous support for both static and dynamic address allocation (two independent IPs)
1
1
.
.
2
2
M
M
o
o
d
d
e
e
m
m
S
S
u
u
p
p
p
p
o
o
r
r
t
t
The Repeater supports two types of integrated modems that required different setup procedures:
• GSM/GPRS – insert SIM card according to section 3.6 and setup up modem according to section
4.7.2.
• CDMA – modem is continuously ON. Setup according to section 4.7.4