User's Manual

ManualsBrandsAxell Wireless ManualsElectronicsD-SBR-3307 LTE Booster

Table Of Contents

High Selectivity Digital 700MHz Repeater
Copyright © 2011 Axell Wireless Ltd
Contact Information
About This Manual
For whom it is Intended
Notice
Confidential - Authorized Customer Use
Disclaimer of Liability
Safety Instructions and Warnings
General Safety Warnings Concerning Use of This System
Exclusive Remedies
Table of Contents
Introduction
- Features
- Modem Support
- Smart-ALC Function
- 3307D Interfaces
Antenna Requirements
- Base (Donor) Antenna
Installation requirements:
- Mobile (Service) Antenna
- High Isolation Requirements - Antenna Considerations
  - Vertical Separation Configuration
  - Horizontal Separation Configuration
Installing the Repeater
- Repeater Pre-Installation Requirements
- Overview of the Installation Procedure
- Required Tools and Materials
- Unpacking
- Mounting the 3307D
- For GPS/GPRS Modems - Inserting SIM Card
- Grounding
- Before Connecting the Antennas or Power
  - Verifying Isolation between Donor and Mobile Antennas
  - Verify Link between BTS and Repeater
- Antenna Connections
- Power-on
- External Alarms and Relay Connections
  - Load Restrictions
    - Alarm Dry Contact Output Restrictions
    - External Alarm Input Restrictions
Initial Setup and Commissioning
- Open a Local WEB Session to the Repeater
- Navigating the Web GUI Application
- Signal Levels and Channel Configuration
  - RF Gain Setting Criteria
  - Adjusting the Signal Levels and Configuring Channels
- Setting Date and Time
- Configuring the External Alarms
- Communication and System Parameters
- Modem Communication Setup
Administrative Operations
- User Management
- Viewing Band Information
- Repeater Software Upgrade
- Backup/Restore of Repeater Configuration
Monitoring and Troubleshooting
- Repeater Alarms and Troubleshooting
- Viewing the Alarms Log
- 3307D LED Troubleshooting
Appendix: 3307D Specifications

AXELL 3307D REPEATER

PRODUCT DESCRIPTION AND USER’S MANUAL

4.7.4 CDMA Modem

4.7.4.1 Configuring for CDMA Modem

To configure for a CDMA modem

1. In the Modem area above, verify that:

• Modem Communication = Always On

• Remote Phone Number = #777 (Verizon)

• Connection Init String = empty field (blank)

• Enterprise ID = 3307.

2. Activate the modem in the Verizon network according to the following section.