User's Manual

AXELL 3307D REPEATER
PRODUCT DESCRIPTION AND USER’S MANUAL
© Axell Wireless Ltd 33
4.7.1 Available Modem Parameter Options
To define the modem parameters
Click CMU in the left tree pane and select the Communication Configuration pane.
In the Modem area, select the Communication mode and define any additional parameters
according to the table below. (Any defined fields in the figure below are only an example!)
In the communication
field, select …
For this communication mode.
Fixed IP.
Modem OFF
Always ON.
Packet Switch mode. (CDMA, GPS/GPRS, etc.).
For GPRS Modem, see section 4.7.2.
For CDMA modem configuration, see section
4.7.4
NOTE: After the modem connects to the network, the Modem IP
Address is displayed.
Direct CS.
Direct Circuit Switch, see section 4.7.3.
IP Callback
Special mode for specific installation types.
4.7.2 GPRS Modem
For GSM/GPRS communication, GSM/GPRS modems are installed. These modems support
both a Packet Switch and a Direct Circuit Switch connection.
NOTE: It is assumed that the SIM card is already installed according to section 3.6
To define the modem parameters
1. Click CMU in the left tree pane and select the Communication Configuration pane.
2. In the Modem area, set the Communication mode as Always ON.
3. Define any additional parameters as required by your operator.
4.7.3 Direct Circuit Switch Connection
A. On the Repeater, set the Repeater Modem parameters (above) as follows:
• Communication - Direct CS
• To provide security, set the User Name and Password for the repeater (the same User
Name and Password will be defined on the dial-up connection).