User's Manual

AXELL 3307D REPEATER
PRODUCT DESCRIPTION AND USER’S MANUAL
26 © Axell Wireless Ltd
4.3.2 Adjusting the Signal Levels and Configuring Channels
The Control and Params (parameters) window is used to configure each of the 700 MHz sub-bands
and Max UL/DL Power. This section describes each of the fields.
Up to 8 or 12 sub-bands referred to as filters can be defined, where each sub-band is individually
defined by setting the following:
• Bandwidth (start and stop frequency) - each sub-band can be set over the full LTE for the
following bandwidths: 1.4MHz, 3MHz, 5MHz, 10MHz or 15MHz
• Maximum power
• Maximum gain
• Gain delta
The defined sub-bands are displayed in the lower part of the screen for reference.
To adjust the signal levels and configure the channels
1. In the topology tree, click Root and click LTE.
2. Click the Control and Params tab. The corresponding pane appears.
The window is divided into the following areas:
• System – overall parameters for the selected service.
• Filter definitions – used to define up to 8/12 sub-bands and their RF parameters.
• Sub-bands view – graphical display of defined sub-bands for the service. The view is
divided into two: lower A,B,C band (left) and Upper C band (right)
Defined Lower A,B,C
band channels
Defined
Upper C
band channels
Service level
parameters
Click Send with
each change
Sub-band definition
options