User's Manual
Table Of Contents
- High Selectivity Digital 700MHz Repeater
- Copyright © 2011 Axell Wireless Ltd
- Contact Information
- About This Manual
- For whom it is Intended
- Notice
- Confidential - Authorized Customer Use
- Disclaimer of Liability
- Safety Instructions and Warnings
- General Safety Warnings Concerning Use of This System
- Exclusive Remedies
- Table of Contents
- Introduction
- Antenna Requirements
- Installation requirements:
- Installing the Repeater
- Initial Setup and Commissioning
- Administrative Operations
- Monitoring and Troubleshooting
- Appendix: 3307D Specifications
AXELL 3307D REPEATER
PRODUCT DESCRIPTION AND USER’S MANUAL
© Axell Wireless Ltd 23
• Click OK. The computer communication parameters are now defined and you can
open a session to the Repeater.
4.1.3 Login to the Repeater
NOTE: The Repeater is factory assigned the address 192.168.1.253. Initial login is performed using
this address; however it is recommended to make the necessary modifications according to
information provided by your network administrator.
To login to the Repeater
1. Open one of the Flash-enabled browsers listed in the system requirements.
2. In the address line, enter the IP address of the Repeater. http://192.168.1.253. A session will be
established with the Repeater an the login dialog appears.
3. Type the default User Name admin and the default Password admin.
Note that both are case sensitive and must be entered with lower case letters.
4. Click Login. The application main window appears.
5. Quickly review the following section describing the application window and then proceed to
configure the signal levels according to section
4.3 0.