User's Manual

ManualsBrandsAxell Wireless ManualsElectronicsD-SBR-3307 LTE Booster

Table Of Contents

High Selectivity Digital 700MHz Repeater
Copyright © 2011 Axell Wireless Ltd
Contact Information
About This Manual
For whom it is Intended
Notice
Confidential - Authorized Customer Use
Disclaimer of Liability
Safety Instructions and Warnings
General Safety Warnings Concerning Use of This System
Exclusive Remedies
Table of Contents
Introduction
- Features
- Modem Support
- Smart-ALC Function
- 3307D Interfaces
Antenna Requirements
- Base (Donor) Antenna
Installation requirements:
- Mobile (Service) Antenna
- High Isolation Requirements - Antenna Considerations
  - Vertical Separation Configuration
  - Horizontal Separation Configuration
Installing the Repeater
- Repeater Pre-Installation Requirements
- Overview of the Installation Procedure
- Required Tools and Materials
- Unpacking
- Mounting the 3307D
- For GPS/GPRS Modems - Inserting SIM Card
- Grounding
- Before Connecting the Antennas or Power
  - Verifying Isolation between Donor and Mobile Antennas
  - Verify Link between BTS and Repeater
- Antenna Connections
- Power-on
- External Alarms and Relay Connections
  - Load Restrictions
    - Alarm Dry Contact Output Restrictions
    - External Alarm Input Restrictions
Initial Setup and Commissioning
- Open a Local WEB Session to the Repeater
- Navigating the Web GUI Application
- Signal Levels and Channel Configuration
  - RF Gain Setting Criteria
  - Adjusting the Signal Levels and Configuring Channels
- Setting Date and Time
- Configuring the External Alarms
- Communication and System Parameters
- Modem Communication Setup
Administrative Operations
- User Management
- Viewing Band Information
- Repeater Software Upgrade
- Backup/Restore of Repeater Configuration
Monitoring and Troubleshooting
- Repeater Alarms and Troubleshooting
- Viewing the Alarms Log
- 3307D LED Troubleshooting
Appendix: 3307D Specifications

AXELL 3307D REPEATER

PRODUCT DESCRIPTION AND USER’S MANUAL

4.1.2 Configure the Computer Network Parameters

Configure the computer network parameters to communicate with the Repeater. Note that the

procedure may vary slightly depending on the operating system installed on your computer. The

following procedure is for Windows 7.

To configure the computer’s network parameters:

1. Click the Start menu and choose Control Panel.

2. In the Control Panel, click Network and Internet.

3. Click Network and Sharing Center and then click Local Area Connection.

The Local Area Connections Status dialog appears with the General tab displayed by default.

4. Click the Properties button in the displayed Local Area Connection Status dialog.