User's Manual
Table Of Contents
- High Selectivity Digital 700MHz Repeater
- Copyright © 2011 Axell Wireless Ltd
- Contact Information
- About This Manual
- For whom it is Intended
- Notice
- Confidential - Authorized Customer Use
- Disclaimer of Liability
- Safety Instructions and Warnings
- General Safety Warnings Concerning Use of This System
- Exclusive Remedies
- Table of Contents
- Introduction
- Antenna Requirements
- Installation requirements:
- Installing the Repeater
- Initial Setup and Commissioning
- Administrative Operations
- Monitoring and Troubleshooting
- Appendix: 3307D Specifications
AXELL 3307D REPEATER
PRODUCT DESCRIPTION AND USER’S MANUAL
14 © Axell Wireless Ltd
6. Insert the clamps including the screws in to the upper orifices leading inside the Repeater.
Figure 12. Locking Clamp
7. Using the Allen screwdriver (item 8 in Figure 7. Installation Components), tighten the hex screw
of the clamp.
8. Insert two hex washer head screws (item 3 in Figure 7. Installation Components) including spring
washers (item 4 in Figure 7. Installation Components) and flat washers (item 5 in Figure 7.
Installation Components) into the lower orifices of leading inside the Repeater.
Figure 13. Example of Upper and Lower Orifices
9. Use the Allen screwdriver (8 in Figure 7. Installation Components) to tighten the hex screws.
10. Verify that the Repeater is firmly mounted.
11. Install the SIM card according to the following section; otherwise, close the Repeater cover and
lock it with the four captive hex screws.
Upper orifice Upper orifice
Lower orifice
Lower orifice