User's Manual
Table Of Contents
- High Selectivity Digital 700MHz Repeater
- Copyright © 2011 Axell Wireless Ltd
- Contact Information
- About This Manual
- For whom it is Intended
- Notice
- Confidential - Authorized Customer Use
- Disclaimer of Liability
- Safety Instructions and Warnings
- General Safety Warnings Concerning Use of This System
- Exclusive Remedies
- Table of Contents
- Introduction
- Antenna Requirements
- Installation requirements:
- Installing the Repeater
- Initial Setup and Commissioning
- Administrative Operations
- Monitoring and Troubleshooting
- Appendix: 3307D Specifications
AXELL 3307D REPEATER
PRODUCT DESCRIPTION AND USER’S MANUAL
12 © Axell Wireless Ltd
3.5.2 Installing the Mounting Bracket
To install the mounting bracket
1. Insert the four wedge anchors (see item no. 2 in Figure 7. Installation Components) into the
drilled holes and secure them with an adjustable wrench.
2. Remove the hex nut, spring washer and flat washer from each wedge anchor, revealing a screw
from each anchor.
3. Insert a flat washer 28mm in diameter in each of the anchors (see item 7 in Figure 7. Installation
Components).
4. Fit the support bracket on to the anchors (see installation direction in Figure 7. Installation
Components) and secure with the flat washers, spring washers and hex nuts removed in step 2.
5. Verify that the bracket is firmly mounted.
6. Connect the power cable to the power supply and route it to the bottom of the bracket, connect it
to the repeater power input.
7. Connect the AC power cable to the AC power input when instructed to do so.
Figure 9. 3307D Mounting Holes and Pins
2x bottom holes
2x top holes
AC cable
To Repeater
IP65 Weather
resistant PS