User Manual

A XELL D-MBR-USA R EPEATER
PRODUCT DESCRIPTION AND USER’S MANUAL
46 Axell Wireless Ltd
6.4 D-MBR-USA Front Panel LED Troubleshooting
The D-MBR-USA Repeater includes LED indicators for each supported band on its front panel (see
1.4) in addition to the two Ethernet LEDs. The following table provides a description of the Service
and Ethernet LED statuses and troubleshooting procedures.
LED Color Status and Probable
Cause
Recommendation
Service Green Normal operation -
Red Major error The Repeater must be replaced
Blinking
Orange/red
User mute
System mute
- Due to isolation problem
or temperature
Check gain of repeater. If gain is
minimum, then it is likely an isolation
problem -> improve the isolation.
Reset the Repeater by turning if off
and on again. If the fault continues,
replace the unit.
CCD Blinking Green System initiating -
MDM Steady Green Modem isn’t defined or
modem operating
normally.
Blinking Green Modem is trying to
connect.
Steady Red Modem is trying to
connect