User Manual

A XELL D-MBR-USA R EPEATER
PRODUCT DESCRIPTION AND USER’S MANUAL
34 Axell Wireless Ltd
4.7.2.2 Activating the modem in the Verizon network
WARNING!!! Settings of the Modem are sensitive to changes. Insert values and
parameters with particular care in order to enable the remote connection.
Below is the activation procedure for the modem in the Verizon Wireless Network.
1. Open the Repeater and connect the RS-232 cable (provided in the accessory kit) to the CMU
card RS-232 connector.
2. Open HyperTerminal with (or eqvivalent program)
3. Set connection speed to 115,200, no flow control.
4. Type AT  and you should get a response OK.
5. Use the command ATD*22899; (ensure there is a semi-colon “;” after the dial string, otherwise
you will make a circuit data call). This will start your OTASP (Over-The-Air, Service
Provisioning) session.
The following messages should be displayed:
• +WOT1: “Programming in Progress”
• +WOTS: “SPL unlocked”
• +WOTP: “PRL download OK”
• +WOTM: “MDM download OK”
• +WOTC: “Commit successful”
• +WOT2: “Programming Successful!”
CDMA Modem
Connect supplied RS232 cable to RS-232
connector.
After completing the modem setup, be sure
to remove the cable CAREFULLY so as to
avoid damaging the adjacent Ethernet
connector.
CDMA Modem