User Manual

A XELL D-MBR-USA R EPEATER
PRODUCT DESCRIPTION AND USER’S MANUAL
26 Axell Wireless Ltd
Note: The following pane shows the LTE Control and Params tab (other band tabs are similar,
except for the parameter values).
Figure 4-6. Params and Control Tab
3. In the System area:
• Verify that the RF Transmission Enable parameter is checked. (This parameter is
used to disable (and re-enable) RF transmission for the band.)
• Set the user defined maximum output signal level for this band by defining the Max
Composite DL Output Power according to your site requirements (click Send). (The
Measured Composite DL Output Power is displayed in the adjacent field.)
If the Max Composite DL Output Power composite output power exceeds the defined
value, the Smart ALC feature begins working.
• Set the Max Composite UL Output Power according to your site requirements.
This is the maximum output signal level for this band.
Service level
parameters
sub-band
definitions
Click
Send
with
each change
Defined
Lower A,B,C
band channels
Defined Upper C
band channels