User Manual
Table Of Contents
- 1 Introduction
- 2 Antenna Requirements
- 3 Installing the Repeater
- 4 Initial Setup and Commissioning
- 5 Administration
- 6 Maintenance and Troubleshooting
- Appendix A: Specifications
Axell BSR 3308-PS NFPA
Product Description and User’s Manual
© Axell Wireless Ltd Doc PN 4000004131 Rev. 2.7 45
5.3 Software Upgrade
The software upgrade procedure consists of two steps: CMU and Band level upgrade.
Depending on the version, you may be required to upgrade either one or both modules.
This section describes both upgrade procedures.
5.3.1 CMU Software Upgrade
The procedure described in this section is used to upgrade the repeater's CMU software.
NOTE: This procedure is performed for every new management version.
The CMU SW upgrade procedure consists of loading the available updated versions and
installing it in the Repeater.
To Upgrade the CMU SW
1. From the Tree Pane, select CMU.
2. Select the Axell CMU SW Upgrade tab. The CMU SW Upgrade screen shown below
appears.
3. Choose the version to upload and perform the procedure according to the
instructions displayed on-screen.