User Manual
Table Of Contents
- 1 Introduction
- 2 Antenna Requirements
- 3 Installing the Repeater
- 4 Initial Setup and Commissioning
- 5 Administration
- 6 Maintenance and Troubleshooting
- Appendix A: Specifications
Axell BSR 3308-PS NFPA
Product Description and User’s Manual
38 Doc PN 4000004131 Rev. 2.7 © Axell Wireless Ltd
4.6.2 IP Address Configuration
The Repeater simultaneously supports two IP addresses: a Local address and a DHCP
address. A unique technology enables applying both types to the same Ethernet port.
Both addresses may enable local and remote management.
• Local IP Address – Static IP assigned by the user to the system. The default Static IP
address is 192.168.1.253. It is highly recommended to preserve this setup. In case
of a change, make sure you record the newly assign IP.
• DHCP Address – address assigned by DHCP server – used for remote management
via an Ethernet connection.
To assign the unit IP addresses
1. Access the CMU Configuration tab (see
4.6.1).
2. You may modify the Local IP Address and relevant parameters. Note that this is
the address required when connecting locally for setup. Be sure to record the new
address.
3. To setup an additional DHCP address – checkmark the Request Additional DHCP
Address. If a DHCP Server is available, the Address will be displayed in the DHCP
Address field.
4. Click Send to apply changes.