User Manual
Table Of Contents
- 1 Introduction
- 2 Antenna Requirements
- 3 Installing the Repeater
- 4 Initial Setup and Commissioning
- 5 Administration
- 6 Maintenance and Troubleshooting
- Appendix A: Specifications
Axell BSR 3308-PS NFPA
Product Description and User’s Manual
© Axell Wireless Ltd Doc PN 4000004131 Rev. 2.7 35
4.4 Configuring the External Alarms
Any connected alarms (section 3.10) must be enabled and configured according to the
instructions provided in this section.
To configure external alarms
1. Click on CMU in the tree pane.
2. Click the External Alarms tab. The following dialog appears.
3. For each connected alarm:
• Checkmark the Active checkbox.
• Set the alarm Normal Mode as High or Low.
• In the Description field, assign the alarm an identifiable name.
NOTE: Each external alarm status is displayed under Axell-CMU Alarms. See section 6.4 for details.
Click
CMU
External
Alarms tab