User Manual
Table Of Contents
- 1 Introduction
- 2 Antenna Requirements
- 3 Installing the Repeater
- 4 Initial Setup and Commissioning
- 5 Administration
- 6 Maintenance and Troubleshooting
- Appendix A: Specifications
Axell BSR 3308-PS NFPA
Product Description and User’s Manual
34 Doc PN 4000004131 Rev. 2.7 © Axell Wireless Ltd
4.3.3 Verify No Alarms are Generated
After the required coverage is attained for the location, verify that no Alarms are
generated before connecting to the main control center.
To view alarms
1. Click the Alarms tab (alarms are described in
6.2.2.
2. Verify that all the indicators (except for the Panel Switch Mask that is not relevant)
are GREEN in the Alarms tab
3. For a full description of the alarms, refer to section
0 6.2.2. The following example
shows an Alarms screen with a Power below Threshold fault.