User Manual
Table Of Contents
- 1 Introduction
- 2 Antenna Requirements
- 3 Installing the Repeater
- 4 Initial Setup and Commissioning
- 5 Administration
- 6 Maintenance and Troubleshooting
- Appendix A: Specifications
Axell BSR 3308-PS NFPA
Product Description and User’s Manual
© Axell Wireless Ltd Doc PN 4000004131 Rev. 2.7 33
5. You may fine tune the position of the filter by using the Shift options (frequency
offset) to lower or increase the channel Start Frequency by up to 500 kHz. (Shift
options).
The selected deviation will be added to the positioning of the filter. For example, if you select
250 KHz shift for the 865 MHz start frequency, the DL and UL frequencies will be displayed as
follows: DL Freq. range: 864.75 MHz-867.75 MHz
6. Click Send. The following responses will be displayed:
• The DL and UL frequency ranges and the Channel will be displayed
according to the selection.
• If the bandwidth selection is within the valid range, the relevant block in
the allocation map at the bottom of the pane will be colored green.
If the input is invalid or out of range the following warning message will be displayed at the
bottom of the window: Status: Error, selected frequency exceed band limit