User Manual
Table Of Contents
- 1 Introduction
- 2 Antenna Requirements
- 3 Installing the Repeater
- 4 Initial Setup and Commissioning
- 5 Administration
- 6 Maintenance and Troubleshooting
- Appendix A: Specifications
Axell BSR 3308-PS NFPA
Product Description and User’s Manual
© Axell Wireless Ltd Doc PN 4000004131 Rev. 2.7 25
4.1.2 Configure the Computer Network Parameters
Configure the computer network parameters to communicate with the Repeater. Note
that the procedure may vary slightly depending on the operating system installed on
your computer. The following procedure is for Windows 7.
To configure the computer’s network parameters:
1. Click the Start menu and choose Control Panel.
2. In the Control Panel, click Network and Internet.
3. Click Network and Sharing Center and then click Local Area Connection.
The Local Area Connections Status dialog appears with the General tab displayed by default.
4. Click the Properties button. The Networking tab appears.
5. In
the Items list, double-click the “Internet Protocol Version 4 (TCP*IPv4)” item.