User Manual

Axell BSR 3308-PS NFPA
Product Description and User’s Manual
24 Doc PN 4000004131 Rev. 2.7 © Axell Wireless Ltd
4 Initial Setup and Commissioning
This section provides the setup procedures for the BSR 3308 Repeater. The Repeater is
designed for simple plug-and-play operation with only minimal configuration
requirements.
Perform the setup procedure according to the following steps:
1. Open a local Web session to the Repeater (this requires configuring the
communication parameters of the computer used).
2. If you are not familiar with the Axell Web Access application, it is recommended to
quickly review the Navigating the Web GUI Application section.
3. Optional – modify maximum gain and output power.
4. Set the sub-band.
5. Verify that no Alarms are generated before connecting to the main control center.
6. Set the Repeater time and date.
7. Optional - Configure the external alarms.
8. Configure the system parameters.
4.1 Open a Local WEB Session to the Repeater
4.1.1 Connecting to the Repeater
To connect Repeater to computer
Interconnect the computer and the Repeaters’ front panel Ethernet ports with the
supplied Ethernet cross-cable as shown below.
Figure 4-1. Local Ethernet Cross-cable Connection
Cross-cable