User Manual
Table Of Contents
- 1 Introduction
- 2 Antenna Requirements
- 3 Installing the Repeater
- 4 Initial Setup and Commissioning
- 5 Administration
- 6 Maintenance and Troubleshooting
- Appendix A: Specifications
Axell BSR 3308-PS NFPA
Product Description and User’s Manual
16 Doc PN 4000004131 Rev. 2.7 © Axell Wireless Ltd
6. Insert the clamps including the screws in to the upper orifices leading inside the
Repeater.
Figure 3-6. Locking Clamp
7. Using the Allen screwdriver (item 8 in Figure
3-1), tighten the hex screw of the
clamp.
8. Insert two hex washer head screws (item 3 in Figure
3-1) including spring washers
(item 4 in Figure
3-1) into the lower orifices of leading inside the Repeater.
9. Use the Allen screwdriver (8 in Figure
3-1) to tighten the hex screws.
10. Verify that the Repeater is firmly mounted.
11. Close the Repeater cover. Do not lock yet since you will need to open it to perform
the Local setup procedure.
Upper orifice
Lower orifice
Lower
orifice
Upper orifice