User Manual
Table Of Contents
- 1 Introduction
- 2 Antenna Requirements
- 3 Installing the Repeater
- 4 Initial Setup and Commissioning
- 5 Administration
- 6 Maintenance and Troubleshooting
- Appendix A: Specifications
Axell BSR 3308-PS NFPA
Product Description and User’s Manual
© Axell Wireless Ltd Doc PN 4000004131 Rev. 2.7 15
3.5.4 Mounting the Repeater
1. Pick up the Repeater and align the Repeaters’ four installation holes with the
Mounting Brackets’ pins.
2. Slide the brackets pins through the Repeater holes until the upper side is locked with
the installation head nuts at the top of the bracket. See Figure
3-5.
3. Release the four captive screws locking the Repeater cover.
Figure 3-4. Loosen Captive Screws and Swing Open Door
4. Swing the top cover open.
Figure 3-5.BSR 3308 Mounted on Support Bracket
5. Set both clamps with a hex washer head screw (item 3 in Figure
3-1).
Bracket pin
Repeater
installation hole