User Manual
Table Of Contents
- 1 Introduction
- 2 Antenna Requirements
- 3 Installing the Repeater
- 4 Initial Setup and Commissioning
- 5 Administration
- 6 Maintenance and Troubleshooting
- Appendix A: Specifications
Axell BSR 3308-PS NFPA
Product Description and User’s Manual
© Axell Wireless Ltd Doc PN 4000004131 Rev. 2.7 13
3.5 Mounting the BSR 3308
3.5.1 Pre-Mounting Procedure
1. Choose the location of the Repeater on the wall according to the following criteria:
• The location should be at normal eye level height, above ground.
• Be sure to allow easy access to the Repeater for maintenance and on-site
inspection.
2. Place the Mounting Bracket against the wall and mark the four holes to be drilled at
the extreme four corners of the bracket (additional optional installation holes are
also provided).
3. Drill four holes 12mm in diameter and 65mm in depth.
The following illustration shows the bracket with the bracket pins.
NOTE: The figure illustrates an AC repeater model bracket assembly. The DC bracket assembly
does not include a power converter and is fed directly by a ±48VDC battery.
Figure 3-2. BSR 3308 Mounting Holes and Pins
Optional
installation holes
Optional
installation holes
2x bottom holes
2x top holes
Assembled PS
(AC models only)