User Manual
Table Of Contents
- 1 Introduction
- 2 Antenna Requirements
- 3 Installing the Repeater
- 4 Initial Setup and Commissioning
- 5 Administration
- 6 Maintenance and Troubleshooting
- Appendix A: Specifications
Axell BSR 3308-PS NFPA
Product Description and User’s Manual
© Axell Wireless Ltd Doc PN 4000004131 Rev. 2.7 11
• NFPA installation – (if required) connect the power via the UPS (for AC
models) or to a ±48VDC trickle charged battery (for DC models) (see 3.9).
9. Dry-contact alarms (this can be done at any time, before or after powering up the
Repeater):
• Standard (non-NFPA) installation – optional.
• NFPA installation - connect the Alarms from the Repeater and (if required)
from the UPS to the Fire Department Control module (see 3.10.5).
10. Commission the system. See Chapter
4.
3.3 Required Tools and Materials
The following tools are required for the BSR 3308 installation procedure:
• Standard professional tool box (not supplied)
• Adjustable wrench (not supplied)
• Power Drill Driver (not supplied) - supporting 12 mm concrete drills
• Allen screwdriver (supplied)